| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Dynapath Discuss Dynapath conrol software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-14-2009, 11:17 AM
| |||
| |||
 Kondia w Delta20 spindle problem I have a Kondia FV1 3Axis CNC w Delta 20 and Ac Pro Toolmaker. When I got it, I noticed the backgear lever was way pass Hi at 12 o'clock. I pulled the lever and it slipped down into the Hi mark at 9 o'clock. Now it won't go back up to 12 o'clock. It won't move. Later on, lo and behold, I found that the M03 command does not work. Dynapath seems to think the spindle is running as there is no fault/status message. Apparently by pulling down the backgear lever like that i disengaged the spindle control and put the variable head into manual. Otherwise, the machine works fine and is in very good condition. I went around with the ohmmeter too. I highly doubt there is anything wrong mechanically or electrically. Does anybody know how i get back spindle control? Last edited by Cadfile; 09-14-2009 at 04:23 PM.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clausing Kondia FV-1 CNC (3-axis) | mtechserv | Knee Vertical Mills | 6 | 06-07-2008 11:27 AM |
| Problem- Kondia/Dynapath 10M Travel Limits Problem | ballchain | General CNC (Mill and Lathe) Control Software (NC) | 11 | 05-07-2008 07:41 PM |
| KONDIA milling machine with TNC 407 | Ramadanzerar | Vertical Mill, Lathe Project Log | 0 | 06-30-2007 04:07 AM |
| kondia CNC conversion | rgv500 | Vertical Mill, Lathe Project Log | 2 | 02-01-2007 12:43 AM |
| Bridgeport clone (Kondia) | andrewbishop66 | Bridgeport and Hardinge Mills | 3 | 11-14-2005 03:26 AM |
| | |
Linear Mode
