Newbie with Dynapath 20 Controller - Page 3 - CNCzone.com-The Largest Machinist Community on the net!

lavrgs · #25 05-27-2009, 11:36 AM

Where's the second one? I don't see one that's in the same package on the AUX board. Did you jumper broken traces? I guess I haven't looked closely enough to know if I have any that are open.

Nandop · #26 05-27-2009, 12:20 PM

Yes i did jumper the broken traces.
Take a look of the attached file to found the crystal oscillator.
Nandop

lavrgs · #27 05-27-2009, 07:11 PM

Are they both the same frequency?

Nandop · #28 05-28-2009, 06:01 AM

The one in the middle is:
6.000 MHz
306000
ITT 0585

The one next to the battery is:
NEL
C1640N
3.6864 MHz
8645

Nandop

lavrgs · #29 05-28-2009, 09:17 AM

Using a heat gun I was able to remove the remnants of the rubber and de-solder the can right off the upper crystal ...eek that's hot. Once I removed the rubber from the traces on the 6MHz crystal I could see an open trace. I'll try and fix it and see if any joy comes out of that.

Thanks Nandop!!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need help with a Dynapath 20 controller!	cjs83	Machine Problems, Solutions , Wireless DNC, serial port	7	12-15-2010 12:44 AM
Newbie - Building the 4X4 - Need Controller Help	tinygiants	Joes CNC Model 2006	2	10-23-2008 08:21 PM
Newbie needs help with 3 axis controller	allanwinks	Stepper Motors and Drives	2	11-17-2007 11:36 AM
Newbie, Which Controller (Kits) can handle big CNC accurately ? step or servo ?	Calico	General Electronics Discussion	3	05-28-2007 05:44 PM
newbie servo controller questions	alphamail	General Electronics Discussion	4	01-25-2007 03:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)