Need Help! dynapath 20m " In Position " problem


Results 1 to 2 of 2

Thread: dynapath 20m " In Position " problem

  1. #1
    Registered
    Join Date
    Mar 2017
    Location
    South Africa
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default dynapath 20m " In Position " problem

    Good day all

    I have a VMC fitted with Delta Dynapath 20M.I have a problem with machine loosing postion in G00 command.If i program a line "G00 X0 Y0 " and hit start in mode 3, machine will rapid from home to "X0 Y0" then pass its program position in sort of a creep motion until it hits its soft limits. This fault only occurred after i had repaired the aux board,and/or re tuned the axis lag.I am currently dripping programs to machine with bobcad cam forcing "G00" code to run as "G01F18000".
    Any help will be greatly appreciated.

    Also i would like to add that by replacing old rs232 memory chips and oscillating crystals has made the control process information much faster than before,almost to highspeed machining.I would be glad to share information about replacement chips if anyone is interested.

    Similar Threads:


  2. #2
    Registered
    Join Date
    Mar 2017
    Location
    South Africa
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Re: dynapath 20m " In Position " problem

    Anyone out there?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

dynapath 20m " In Position " problem
dynapath 20m " In Position " problem