Delta 20 screen running? - CNCzone.com-The Largest Machinist Community on the net!

mt92 · #1 11-17-2011, 08:06 PM

I just started using a tree mill with a dynapath delta 20 control.
The only problem I have ran into with the machine function is the screen will run occasionally like an old tv set.
Is there an adjustment on it to correct this?

T0DD · #2 11-18-2011, 10:13 AM

Common problem. Most people just smack the left side of the control pretty hard. They have been doing that to the one here for 14 years!

Todd

hmc710 · #3 11-18-2011, 10:21 AM

There are also the typical Horz Vert Contrast control pots inside the cabinet if the above method does not work.

T0DD · #4 11-18-2011, 12:08 PM

Agreed, trying to fix the problem is what I would try to do, the service tech said smacking the control works for him. Mine hasn't done that yet so I've not been able to try the adjustment method yet.
Todd

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Delta 10 / 20 CRT screen issues	hmc710	Dynapath	2	11-23-2011 02:40 PM
2 ?'s split screen views for two different parts and x5 clipboard picture screen	g29cc	Mastercam	2	09-01-2011 09:44 PM
Homemade Screen Printer/Silk Screen	Sbthomas13	Machine Created Art	20	02-13-2009 06:35 PM
how to set a touch screen on the screen of mach 3	cob	Mach Mill	6	07-13-2008 05:28 PM
Wye-delta, delta-wye configurations?	mackeym	Phase Converters and VFD	10	09-27-2006 05:02 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)