| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Dynapath Discuss Dynapath conrol software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-17-2011, 08:12 PM
| |||
| |||
I'm helping a friend out on a lagunmatic vertical mill with a delta 20 controller, if we faulted on a travel limit, or a hardware limit we could not figure out how to override the fault to move the machine off the limit switch (without removing the switch itself) What is the process to override one of these faults? ,Andrew  |
|
#2
07-18-2011, 09:44 AM
| |||
| |||
| If it's anything like the Tree mills with that control, you removed a cap on the end of the ballscrew, stuck a socket wrench in and turned it off by hand. |
|
#3
07-18-2011, 09:42 PM
| |||
| |||
| on mine, you push the fault key then hit reset and then it will move in the jog mode(away from the switch of course).... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Delta 20 rapid travel | jdracing | Dynapath | 1 | 04-16-2010 07:36 PM |
| Need Help!- Problem with wiring limit switches to Delta Tau Pmac | jatchan | Servo Motors and Drives | 1 | 02-09-2009 07:41 AM |
| are travel stops required? or are limit switches enough | multiplex | DIY-CNC Router Table Machines | 20 | 12-14-2007 10:11 PM |
| How close to the end of your travel do you have your limit switches? | dmgdesigns | DIY-CNC Router Table Machines | 9 | 10-27-2005 07:47 PM |
| limit switch override | swarfmacdaddy | TurboCNC | 5 | 12-12-2004 03:47 AM |
| | |
Linear Mode
