| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Dynapath Discuss Dynapath conrol software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-30-2010, 10:19 AM
| |||
| |||
I've acquired a Lagun CNC mill with a Dynapath Delta 10 controller. While it's a nice self contained, high quality unit, I've decided I want a different control system, specifically I want to build my own using Emc2 and some custom electronics. To give me a leg up on assembling funds for this I want to sell the Delta 10, which is in good working condition. Where's the best place to sell something like this? Do you think anyone would buy the parts, or should I try to sell the whole unit? I may end up going with E-bay by default, I don't think I'd get a lot of inquiries on craigslist... Thanks, Erik  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Delta Tau | cnc-it | General CNC (Mill and Lathe) Control Software (NC) | 3 | 04-29-2008 11:07 PM |
| Where is a good place to sell equipment? | conceptmachinin | General Metalwork Discussion | 3 | 12-07-2007 01:35 PM |
| Best place to sell a used taig mill? | Camfather | Taig Mills & Lathes | 2 | 07-25-2007 08:51 PM |
| Wye-delta, delta-wye configurations? | mackeym | Phase Converters and VFD | 10 | 09-27-2006 05:02 PM |
| | |
Linear Mode
