- Please Help! - DynaCNC 4000 Blowing Z Axis Fuses
-
Registered
Please Help! - DynaCNC 4000 Blowing Z Axis Fuses
I have a very large DynaCNC table with a Z axis problem. As soon as I reset Mach 3, the control box kicks in, then out and blows the 10 amp mini auto style fuse. It just started doing this and happens as soon as the reset is pressed on Mach 3. Any ideas on what to check or how to go about troubleshooting would be greatly appreciated. Thanks in advance.
Thanks,
Brian
Similar Threads:
-
-
Member
Re: Please Help! - DynaCNC 4000 Blowing Z Axis Fuses
try swapping gecko's between z and x or y and see if the problem follows the gecko.
- Please Help! - DynaCNC 4000 Blowing Z Axis Fuses
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules