Results 1 to 2 of 2

Thread: 1st post! Newbie help.

  1. #1
    Registered
    Join Date
    Feb 2010
    Location
    U.S.
    Posts
    1
    Downloads
    0
    Uploads
    0

    1st post! Newbie help.

    Thanks Fastest 1. Much appreciated.
    Last edited by Fly'n WV; 02-18-2010 at 08:21 AM.


  2. #2
    Tinkerer
    Join Date
    Nov 2009
    Location
    USA
    Posts
    2,319
    Downloads
    0
    Uploads
    0
    Jump on it! I just bought a 3000 lathe of Dyna's that I am about to refit with Geckodrives etc. After cleaning mine up and becoming familiar with their construction. These are very well built. If you could pick one up that cheap or somewhere close to that, do it. You wouldnt be able to find a hobbyist mill with those features or rigidity for anywhere near these prices. I will be doing a refit on this forum, I would bet most of the electronics are the same. Smart to remove any links or show that web address as there is a lot of interest here. Good Luck and hope to see you back here soon.


Similar Threads

  1. Dyna Myte 2400
    By Bertake in forum General Metal Working Machines
    Replies: 3
    Last Post: 04-14-2013, 09:39 AM
  2. Dyna Myte 2400 Manuals
    By azbret in forum Want To Buy...Need help!
    Replies: 2
    Last Post: 05-23-2011, 04:26 AM
  3. Need Help!- Dyna Myte 2400 Programming help
    By azbret in forum Want To Buy...Need help!
    Replies: 1
    Last Post: 12-27-2008, 02:26 AM
  4. Need Help!- Dyna Myte 2400 mill
    By Peter Gibbs in forum Benchtop Machines
    Replies: 9
    Last Post: 10-12-2008, 07:02 PM
  5. DYNA MYTE 2400
    By helfriwj in forum Benchtop Machines
    Replies: 4
    Last Post: 04-01-2008, 11:45 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.