| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Dyna Mechtronics Discuss Dyna Mechtronics here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-24-2011, 04:48 PM
| |||
| |||
My transformer (under the control cabinet) output is 38 volts where it's supposed to be 115 volts. Is there a suitable replacement? Anything that fits? Schematic calls it a 1.05KVA. Or can I simply bypass the transformer since my line voltage runs 118-122 volts?  |
|
#2
08-07-2011, 05:46 PM
| |||
| |||
I measured the voltage across the wrong terminals. Bypassed it & it still didn't work, found out it's the power supply. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- ETD29 transformer core/bobbin needed | lovebugjunkie | General Electronics Discussion | 3 | 10-06-2010 11:47 PM |
| DM2800 (escap stepper wiring config needed) | cncinbama | Dyna Mechtronics | 5 | 08-09-2010 05:01 PM |
| DM2800 Questions | bender88 | Dyna Mechtronics | 1 | 08-06-2010 06:07 PM |
| 24VAC 10A transformer needed in New Zealand | blasttiod | Hobbycnc (Products) | 5 | 08-28-2008 11:39 AM |
| 3 phase transformer needed | pauluk | General Electronics Discussion | 1 | 12-26-2005 03:02 PM |
| | |
Linear Mode
