Build Thread- Hot Keys

[jmerson]

I don't know if this has been addressed before but in the Tutorial there have been mentions of Keyboard strokes or hotkeys. I can't seem to find anything about them in the writen part. Anyone have a clue as to where they might be listed? This program has a long learning curve.
Jim

[windy_miller]

I only know of 'R' for re-draw.

I agree, a complete list would be useful. Maybe you could post this request on the yahoo dolphin forum where you will most likely get a relpy from the actual sw writers.

[Dolphin USA]

Good afternoon,

These are the Hot keys used in Cad - Cam doesn't have any.

F = No Snap (Previous version sed the term Finite, hence the F
N = Near snap
G = Grid snap
M =Mid point snap
Q = Quadrant snap
C = Centre point snap - of an Arc or Circle
I = Intersection snap - where two elements intersect.

Other keyboard selections are ;-
Del = Delete - used when you have "Select" to hightlite elements
Shift = Select the end point of an element rather than the element itself - See Dimensions - Help

Pressing any other keys will put the character into the X,Y, coordinate window. The characters allowed here are X,Y,Z,A (Angle) L (Length)

[windy_miller]

Thanks thats great. Will make a little sticky to go on the keyboard. I think you win the competition for the fastest reply

[jmerson]

Windy,
They do watch, don't they? You may not always get an answer but this sure does prove that the site is being watched.
Jim