Results 1 to 2 of 2

Thread: My input

  1. #1
    Registered
    Join Date
    Dec 2007
    Location
    USA
    Posts
    491
    Downloads
    0
    Uploads
    0

    My input

    I would like to go out and say what a wonderful help the support personell at dolphin has been. I ran into an issue and needed help asap last evening. I emailed dolphin expecting to get an answer sometime today. Too my suprise my question was returned within 30 minutes from the time I asked. Support is 2nd to none and would like to publicly say thank you.


  2. #2
    Registered Dolphin USA's Avatar
    Join Date
    May 2007
    Location
    USA
    Posts
    412
    Downloads
    0
    Uploads
    0
    We always value these comments. Thank you.
    Dolphin CAD/CAM Support


Similar Threads

  1. 3 phase input VFD for single phase input?
    By Redhead in forum Phase Converters and VFD
    Replies: 4
    Last Post: 02-27-2008, 11:30 AM
  2. Newbie- I need some input
    By hcker2000 in forum Benchtop Machines
    Replies: 2
    Last Post: 02-18-2008, 08:17 PM
  3. Newbie- stl input
    By jcoats in forum CamBam
    Replies: 1
    Last Post: 02-09-2008, 02:40 PM
  4. I need some input
    By Steve@Reliance in forum CNCzone Club House
    Replies: 2
    Last Post: 09-27-2006, 04:54 AM
  5. Can a 3ph input VFD run on 1ph ?
    By Don Lester in forum Phase Converters and VFD
    Replies: 3
    Last Post: 06-27-2006, 01:51 PM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.