We don't have a post here at Dolphin. However, I did once configure one for a customer in the UK some years ago, can't remember who it was or I would contact them for a copy of it.
I can remember what I did though, I took a basic Fanuc Milling post 'm-f0mf' and took out a load of stuff like G28, G43 etc, so it left a post with only basic movement functions like G00, G01, G02 T1, M06 etc. I think I took out the spindle control as well as this was a manual on/off.
Copied the Gcode file onto a floppy and loaded it into the controller, at first I thought that it hadn't read it in but it had, the biggest drawback was that the Gcode file was not visible on the control, I could only load it into memory and run it. Ran the job OK.
Posting Permissions
LinkBack URL
About LinkBacks
