autocad 2d/3d drawing/render into partmaster? - CNCzone.com-The Largest Machinist Community on the net!

BulleTxMagneT · #1 01-22-2008, 08:40 PM

i have a drawing that i drew up in autocad using solids, how do i get it into partmaster? it wont import the file, help. thanks

Dolphin USA · #2 01-23-2008, 12:10 AM

Depending on which version you have, it may not be able to do so. You will need to import it as a .dxf file. Feel free to PM if need be or send support request directly to us.

Chad_Clark · #3 01-28-2008, 09:39 AM

Originally Posted by BulleTxMagneT

i have a drawing that i drew up in autocad using solids, how do i get it into partmaster? it wont import the file, help. thanks

Dolphin Partmaster is not able to import solids and surfaces it is a wireframe program only. To import solids and surfaces you need the Dolphin 3D CAM.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Partmaster CAM will not run? Help!	Willyb	Dolphin CADCAM	11	10-09-2007 03:14 PM
How can I make this? w/render...	krazatchu	General Metalwork Discussion	1	03-13-2007 06:53 AM
Dolphin Partmaster Level 3	rodneydeeeee	Dolphin CADCAM	0	12-01-2006 03:24 PM
Dolphin Partmaster help for newbie?	bdillard	General CNC (Mill and Lathe) Control Software (NC)	3	01-07-2006 08:36 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)