Is there a BOOK on this????

[Astroguy]

Well I made my first test piece with Dolphin. It is a raisd text plate with my name in 1/4" 6061.



Now my question is how to do it in more than one cut. I had to load the file in Mach3 then set the Z percentage 20 at a time and run it 5 times to get the final depth. It worked but I can not find where in Dolphin Cam to set it up to do .020 cuts one at a time to get .250 depth.

[John S.]

Fred,
Read post # 7 in the 'How to on drilling' thread.
I explained it all there.

John S.

[MIKE JEFFERS]

in your cutter set up (define tool) - cut depth , set it .02

[Astroguy]

Originally Posted by MIKE JEFFERS in your cutter set up (define tool) - cut depth , set it .02

Duh, That was easy. Thanks Mike.