Newbie Fadal Post Processor. - CNCzone.com-The Largest Machinist Community on the net!

neilthib · #1 03-12-2011, 07:30 PM

Dose anyone know if the post processor for Fadal in dolphin cam is capable of producing cod for 4th axis moves?

John S. · #2 03-13-2011, 06:06 AM

Neil,
Take that 4th axis file I posted and run it thru the Fadal PP, then look to see if there are any A axis moves

neilthib · #3 03-13-2011, 08:13 AM

John,
That's what I did and I just get X and Y code. No A axis code.

andre-dolphin · #4 03-14-2011, 05:40 AM

Hello,

We can modify the post to output 4th axis code.

Please contact Michael and see what he advises.

michael@dolphincadcam.com

ATB
André

neilthib · #5 03-15-2011, 07:44 PM

Andre,

I e-mailed Michael like you suggested, but have yet to receive a response. Any other suggestions?

Neil

neilthib · #6 03-17-2011, 11:38 AM

Andre,

Thank's for the help.

Neil

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fadal/Post Processor.	neilthib	Dolphin CADCAM	1	09-23-2010 05:13 AM
Fadal 4th axis post processor	Terrence	Fadal	1	12-15-2008 03:03 PM
FADAL 4020HT post processor HELP!	carbonraptor	Fadal	1	01-17-2008 03:52 PM
MasterCam X post processor for Fadal VMC 15	Sgt.Baker	Post Processor Files	3	04-08-2007 07:18 PM
Fadal CNC 88HS Post Processor Required	cncsydney	General CAM Discussion	3	12-04-2006 12:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)