OK, I have Part master and Mach 3 on the same computer. I'm looking for someone to walk me through getting a run program from the Part master over and loaded up on the Mach 3. What Post Processor do I need? Where do I put it? Hoe do I use it.
I'm very, very new to this all, and need the basic steps.
Anyone up to the challenge?
Watch some of the video's, that's what they are there for.
Then come back with unanswered questions.
I watched the video's first. They don't get into posting a great deal.
I did figure it out though. I was posting pun. instead of tex.
Thats why I wasn't able to find the file when I tried to load it in Mach 3.
Mach..inc. poster wasn't working either. The arc's came out as circles, and squares looked like stars when loaded in Mach 3.
I then found that my Mach 3 Con fig, IJ mode was set Absolute instead of Inc.
Switch that all around, and now it works great.