Did you solve this? You're geometry/profiles are wrong. You should see the complete part in the cam, not half...
HI there I am using Dolphin Cam turning module the problem i have is when i simulate the tool path the tool change goes through the part.
After post processing this runs OK on the HAAS SL20 but looks wrong when checking the tool paths in the software any ideas tried all sorts of setting combinations.
Kind Regards Mark
Similar Threads:
- Spindle drop from Z Home for tool change, is there a way to change distance?
- Dorian Tool SD30BXA Quick Change BXA Tool Post New Unused!
- Need Help!- how do i change the tool change arm parameter ???
- How to change Tool change position(About MAZATROL T1 control)
- How do I change the Tool Change Position?
Did you solve this? You're geometry/profiles are wrong. You should see the complete part in the cam, not half...
I beleive my colleague Michael sorted this out with mods to the post.
ATB
Andre
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)