I build a profile using DCAD, set up the NC profiles, and go to the turning module.
There, I setup the machine type, all tools, and turning operations, goto, etc.
The Run shows the resulting cut.
Then I would like to run a 3d simulation.
I select Execute | 3d Machine tool Simulation, and then use ST_Lathe.ppr
DCAM replies "The Simulator data has been created."
I click OK to run the simulation, but instead, mwSimulator replies
"Error decoding tool select command line.
TURN/TOOL/SELECT/1, TURNING TOOL
System.InvalidCastException: Conversion from string "" to type 'Integer' is not valid...
and a whole bunch of Microsoft VisualBasic exception information.
How to get a simple simulation to run?
This doesn't happen when running a milling simulation.