Which DolphinCAM post processor for Centroid CNCV11 ??

[countryguy]

Hi everyone, Anyone know which Post Processor I should use for my new Centroid retorfit Mill? It's the DC-AIO w/ CNCV11 software. Just not sure what to do there?

Similar Threads:

• DolphinCAM post processor for ajax/Centroid mill contoller?
• Need Help!- post processor for centroid cnc
• Post processor for Solidcam on a Centroid M5 controller?

[countryguy]

According to Centroid, Use anything Fanuc 0m also, IF you take a PPR out as g-code and load it up, if the CNC11 software can load and graph it, It'll cut it. Directly from Support. My only issue is to see if I can figure out which PPR is for Fanuc0m tgif