dyn4 servo creeping or twitching along by itself

Results 1 to 2 of 2

Thread: dyn4 servo creeping or twitching along by itself

  1. #1
    Member
    Join Date
    Apr 2007
    Location
    usa
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default dyn4 servo creeping or twitching along by itself

    I tried wiring in the recommended approach for servo disable signal connecting the 14v pins together on the J4 connector and connecting the ena pin 15 to pin 1 . this approach worked on the X servo and the z servo but my y servo started to do a twitching creep that continues any time the servo is powered up I disconnected wiring I had put in first to the y servo then to the other two thinking it was some sorta noise thing but the twitching creeping continues any time the drive is powered up. Any ideas? thanks Chris



  2. #2
    Member
    Join Date
    Apr 2007
    Location
    usa
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default

    Dmm's tech Tianyu, suggested switching drives or cables this lead to finding a poor crimp on the y axis cable from the breakout board to the dyn4 on the breakout board end reworking the connector solved the problem.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

dyn4 servo creeping or twitching along by itself

dyn4 servo creeping or twitching along by itself