Porter Cable Router Motor Mount

[dowling177]

Hi:

I have built a CNC router table and have bought a Porter Cable Router 3.25HP with a motor diameter of 4inches.

I need to mount this to my z-axis and need a machined motor mount before the 25 of April (since my project is due then). I was planning to get it from K2CNC but they have just moved and I might not get it in time.

I was wondering if anybody makes these and is willing to sell one to me?

If not, does anyone know of any other ppl who may make them?

Thanks

[cnc2k]

can you pre-mount your router to you z axis? If you can, use the g-code on this thread (Post#12)
Router Mount

Hope this helps
CNC2k