PDS Colombo Spindle Dimensions?

[CyborgCNC]

Hello Everyone,

I am designing a new CNC router, to replace my old solsylva, and I am thinking of using a VFD this time around (less noise..).

Been looking at the PDS Colombo spindles, and they seem nice, but their website does not provide many details as to their physical size. I am designing the whole thing in Solidworks, with 8020 extrusions, and linear rails, but I am kind of stuck on my Z-axis. I want the dimensions, so I can better design around them. I am also planning on CNCing the parts.

Does anyone have an rv55 or similar colombo spindle, that they might share the dimensions, and mounting holes?

I might be blind, but have not seen them on their site.

Greatly appreciated, and thank you in advance.

[ger21]

Click the number next to RV55 in the bottom chart, and it'll take you to a page with a .pdf that has dimensions.

http://www.gcolombo.eu/prodotto.htm?categoriaID=67&p=94

[CyborgCNC]

Thank you Gerry!

Prrfect! That is what I was looking for....not sure why they make it so difficult to find on their site.

Thanks again!

[ger21]

Yeah, I was about to give up, but found it the second time through.