Gecko 540 Package from Keling. Good Choice or Not????

[JeLC]

OK guys, I'm asking for advice again. I've got a router table (JPGO design with approx 42" x 36" cutting area). I got software....Mach3 and VCarve. I've got three acme screws with Delrin nuts on the way (which, after reading this forum, I may regret). I've got a wife in shock from me spending all this money on my latest 'toy' (but she'll recover, I'm sure). Now I'm ready to order the electronics package.

The G540 seems to be the way to go. The Keling package also has 387 oz/in motors, and that seems to be a good match. My question.....for $500, is this the best package in that price range???? Also, since I'm using a G540, does that do away with the need for a break out board?

Thanks in advance

[LaserImage]

You can't go wrong with the G540 and Keling combo. The G540 has a built-in bob, so you don't need a separate one.

Gary