Results 1 to 2 of 2

Thread: Motor Question

  1. 02-10-2009, 09:55 PM #1
    buddym
    buddym is offline
    Registered
    Join Date
    Sep 2006
    Location
    US
    Posts
    51
    Downloads
    0
    Uploads
    0

    Motor Question

    Ok, I got these motors, 6 wire, 28 volts, NEMA 23, .21 amps....

    It seems like the voltage is quite high compared to other motors...?

  3. 02-11-2009, 07:35 PM #2
    johnmac
    johnmac is offline
    Registered johnmac's Avatar
    Join Date
    May 2007
    Location
    USA
    Posts
    382
    Downloads
    0
    Uploads
    0
    Correct. Top speed will be slower than motors with a lower voltage rating.

    John

« PDS Columbo 90rv tool changer setup | All Aluminum Router- so far so good »

Similar Threads

  1. stepper motor of x4+ and another question
    By ataxy in forum Syil Products
    Replies: 0
    Last Post: 09-08-2008, 12:24 AM
  2. Motor Question
    By DistortedDesign in forum Joes CNC Model 2006
    Replies: 11
    Last Post: 03-07-2008, 10:01 AM
  3. Stepper Motor question
    By benn0280 in forum Stepper Motors and Drives
    Replies: 6
    Last Post: 01-16-2008, 11:27 PM
  4. Servo Motor question
    By jaslep13 in forum Benchtop Machines
    Replies: 20
    Last Post: 08-23-2006, 09:26 PM
  5. Stepper Motor Question
    By bcromwell in forum General Electronics Discussion
    Replies: 3
    Last Post: 08-31-2004, 03:42 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.