2 drive motors for 1 axis

[WI_HUNTER_DAN]

I see lots of cnc routers for sale with two drive motors on the X axis, who would you drive those motors? I assume you can use a three axis controller board and a Darlington array for two motors accepting the same commands is this right?


WI_HUNTER_DAN

[joecnc2006]

Normally, you use a 4 axis board and slave the drives in software, or another option is use one motor and the use a belt drive to connect to the two leadscrews.

Joe

[digits]

Normally, you use a 4 axis board and slave the drives in software, or another option is use one motor and the use a belt drive to connect to the two leadscrews.

Joe

Is there a good reason why you can't use 2 drives but tie the step and direction pins together so that they look like just one drive to the software?

[joecnc2006]

Is there a good reason why you can't use 2 drives but tie the step and direction pins together so that they look like just one drive to the software?

I tested it with mach and worked but i used a 4 axis drivers, because each drive will need to be powered individually, I just jumpered the step and direction from breakout board.

Joe