LinkBack URL
About LinkBacks
You can get by with ACME screws...unless you want to get down into 0.010 trace spacings....
Check out cnconabudget.com and you can see what Paul did. There is another crankorgan.com .....
| | |
I have searched the Zone and cannot find much info on circuit board router building.Anyone have some links onthe subject?
I have thk ssr15 with short rails{200mm}Can I use only 2 rails and 2 blocks for X&Y?[2 for X 2 for Y].
Any advantage to fixed gantry and movable table?
Do I need to use ballscrews?
Thanks
Larry
You can get by with ACME screws...unless you want to get down into 0.010 trace spacings....
Check out cnconabudget.com and you can see what Paul did. There is another crankorgan.com .....
some links from my wiki: http://www.pminmo.com/wiki/index.php...NC_PCB_Milling
Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
Vist my websites - http://pminmo.com & http://millpcbs.com
Posting Permissions
| | |
