I am looking for a site that has a nice flexible brush in several lengths that I can by by the foot or in small increments (do not need a whole roll). I googled the heck out of it and I came up with tons of sites that are just the manufactures site and have no pricing info.
McMaster-Carr has it by the foot: http://www.mcmaster.com/#strip-brushes/=7sgvmy
Check this thread for more info: http://www.cnczone.com/forums/showth...?postid=784690
Bob
"Bad decisions make good stories."
This looks good, Although I need flexible.... All these seem to have a metal backing that would not be easy to bend.
McMaster Carr has flexible, but it costs about 10 times more.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I found a brush and spade at the $2 shop for under $4. So much for the $2.
The brush section is long and straight (that makes it cheap).
Toss away the handle and the shovel - you end up with too many of them.
The one I found comes with about 10" lengths of brush which I just cut to length and screw to a support ring.
Super X3. 3600rpm. Sheridan 6"x24" Lathe + more. Three ways to fix things: The right way, the other way, and maybe your way, which is possibly a faster wrong way.
Posting Permissions
LinkBack URL
About LinkBacks
