Hey you guys, I'm wondering what USB Stepper controllers are out there. What's everyone using? Right now I have Mach3 through a hobbycnc board. I just got a laptop that doesn't have a parallel port that wanted to use in my shop, hence the need for a usb controller. I really like Mach so is there anything that is compatible? I don't have to stick with it though! I looked around and found a few, but am just wondering what the general consensus is? Should I just stick with my desktop and trusty hobbycnc controller? Thanks!!
Mach3 2010 Screenset
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)