Porter Cable Router Motor Mount - CNCzone.com-The Largest Machinist Community on the net!

dowling177 · #1 04-04-2005, 05:34 PM

Hi:

I have built a CNC router table and have bought a Porter Cable Router 3.25HP with a motor diameter of 4inches.

I need to mount this to my z-axis and need a machined motor mount before the 25 of April (since my project is due then). I was planning to get it from K2CNC but they have just moved and I might not get it in time.

I was wondering if anybody makes these and is willing to sell one to me?

If not, does anyone know of any other ppl who may make them?

Thanks

cnc2k · #2 04-04-2005, 07:40 PM

can you pre-mount your router to you z axis? If you can, use the g-code on this thread (Post#12)
http://www.cnczone.com/forums/showth...t=router+mount

Hope this helps
CNC2k

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
porter cable collets	senor J.	DIY-CNC Router Table Machines	3	07-09-2008 04:40 PM
Porter Cable 690LR Router	CNCRob	DIY-CNC Router Table Machines	39	02-10-2006 05:02 PM
Round 2 :Z axis for porter Cable router	camfambmw5	General Metal Working Machines	2	10-06-2003 12:14 PM
Z axis for porter Cable router	camfambmw5	General Metal Working Machines	5	10-06-2003 09:55 AM
Mounting a porter cable router	camfambmw5	DIY-CNC Router Table Machines	5	09-28-2003 08:38 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)