Where can buy anti-backlash nut online?

[xdev]

Dear All,
I need only anti-backlash nut ( Kerk, Nook, BSA etc.) Where can buy from internet?
Thank.

[DareBee]

Ballscrew, ACME, Metric, Imperial?
Be more specific

[xdev]

I need anti-backlash nut only for use with ACME leadscrew or Trapezoid leadscrew. I have screw.

[Hobbiest]

http://gonebowlin.com/dumpsterCNC/

[xdev]

Dear Hobbiest
DumpsterCNC have only nut for acme leadscrew. I need both acme and trapezoid screw.

[cnc2k]

i think they can do custom backlash nuts, email them to find out.

[Hobbiest]

i think they can do custom backlash nuts, email them to find out.

According to the site he will.

[Woodie1]

I ordered two nuts 3/4-6 Acme Nuts on 1/9/05. He said that he'd make them.
As of today,3/7/05 no nuts. He says "I'm getting quite a few orders that are keeping me busy also".
He woun't return me Emails.
I did get two 1/2" nuts from him on Ebay. Nice nuts!
Larry

[Woodie1]

Originally Posted by Woodie1 I ordered two nuts 3/4-6 Acme Nuts on 1/9/05. He said that he'd make them. As of today,3/7/05 no nuts. He says "I'm getting quite a few orders that are keeping me busy also". He woun't return me Emails. I did get two 1/2" nuts from him on Ebay. Nice nuts! Larry

That Was DumpsterCNC

[ynneb]

cant you make your own with two nuts and a spring washer in between?

[dumpster]

Originally Posted by Woodie1 I ordered two nuts 3/4-6 Acme Nuts on 1/9/05. He said that he'd make them. As of today,3/7/05 no nuts. He says "I'm getting quite a few orders that are keeping me busy also". He woun't return me Emails. I did get two 1/2" nuts from him on Ebay. Nice nuts! Larry

Hi Woodie1,

Glad you liked the 1/2-10's, I've been getting a lot of good feedback on them. Our hobby needs something in between the sloppy steel nuts and expensive ball screws/nuts... I hope I'm helping fill that slot.

Again I'll apologize for not being able to make the 3/4-6 leadnuts. I had told you that I'd "try" to make them and that I couldn't find a suitable spring. Then that I'd have to put your leadnuts on hold due to not having the proper tooling for a thread that deep and I only haven't replied to one email I received a couple days ago... my answer is the same, the 3/4-6 threads require a deep acme threading tool that I don't have.

I also don't have a tool for the trapezoidal (metric acme) threads yet. I'm just getting started at this and it will take a bit to get the specialized tooling.

Tim
dumpsterCNC
http://gonebowlin.com/dumpsterCNC/

[cnc2k]

dumpster,
How accurate can you get with your "nuts"? I'm planning to buy couple 1/2-10 to try out.