no motor output

[eloid]

hello all

just starting to test my system, using a pc, with the smoothsteper brd and
cnc4pc c23 break out brd.... have my estop limitswitch working now,
drivers install for smooth steppper etc....

but dont get any motor output, drives are g203v so i have the jmp1 on bob
set to com=gnd for g203v


I last hurd is the outputs for the motors, when i power my gecko g203v up i get a green ligh on drive...its goood
i can feel the stepper the motor engage, not free turning....


on the c23 output side port 1 this is how i wired my g203v
from my g203 c23output

step--------------------------------------------->x step pin2
dir------------------------------------------------>x dir pin 3
common---------------------------------------> common

on bob enable wire to +5v for outputs

note jp1 jummper set to pin 2,3 which is com=gnd

what am i missing ? i get no output leds? for outputs

[revwarguy]

Are the right size current limiting resistors in place? No resistors, no movement.

[eloid]

Originally Posted by revwarguy Are the right size current limiting resistors in place? No resistors, no movement.

yes have ~32k for 3 Amp setting

[eloid]

was the charge pump
needed a output to pin 17 of c23