Need help identifying motors

[Pukwudji]

I pulled several motors a while back from some copiers. I'm having a hard time finding these models on the internet. I've found some where the numbers are relatively close but I don't know how close you have to get not to burn up your motors. Plus the docs I found on them were in Japanese.

Anyway, if anyone has a source and can help identify these I'd greatly appreciate it. I'm looking for voltage, amperage, ozin rating, and anything else I might need to know to make sure I get the right drivers and don't burn them up.

StepSyn:
103h7853-8053 (I think this one might be a DC motor)

AstroSyn Minebea:
23km-k722-07v
23lm-c047-05v
23km-k381-01v

Japan Servo Co:
KH56KM2R005
KT60KM06-011
KH56LM2B009
KH56LM2B010
KH56LM2B015
KH56LM2B014
KH56JM2V014A03
KH56KM2U043 (I can't read my own writing, that might be V043)

In one doc I found (can't find again now that I'm looking for it, damnit) had a close match to a could (KH56KM2xxx). Only the xxx portion at the end didn't match. Those indicated 834ozin. If that's correct WOOHOO! Of course I can't find that document again and I neglected to write the electrical specs down.

Anyway, any help you folks can offer would be greatly appreciated.

Thanks,
Brian

[Kobra000]

i was wondering if you ever were able to get the specs on the motors,mainly the Japan Servo Steppers

KH56LM2B014

if you did and could tell me the specs on man id really appreciate it.

thanks

Keith.

[auflyer86]

Here is a link to the Japan Servo or Nidec Servo Company catalog. Unfortunately, I haven't found the exact model number you listed. There are similar ones but they could be vastly different electrically. I wonder if this model number were specially manufactured for an OEM...

Anyway, here's the link.

http://catalog.nidec-servo.com/digit...c_ste_ftrs.pdf

Good Luck

[Kobra000]

Hey thanks for posting the PDF file,i consider all information on step motors and the like good info.

umm i was wondering if you could direct me to like the "cnc for Noobs" forum/thread or where i can post a new thread.im new to CNCzone and its kinda hard to find ones way around here.

thanks for your time

Keith.