Need Help! Could someone post there setting for a HY02D223B - CNCzone.com-The Largest Machinist Community on the net!

Ed Williams · #1 05-19-2009, 11:12 AM

On my readout it says 11,520 is my max rpm when it is running at 400hz. I must have something set wrong on my 2.2kv spindle.
Thanks

yngndrw · #2 05-19-2009, 09:01 PM

Do you have it set as 2 poles ?

Ed Williams · #3 05-19-2009, 09:19 PM

No I have it set for 4 poles.

yngndrw · #4 05-20-2009, 07:34 AM

Then setting it as 2 poles should fix it. It looks like it would only read up to 23,040RPM though so I don't know where the other 1,000RPM has gone.

Ed Williams · #5 05-20-2009, 10:43 AM

What is pd144 suppose to be set at.
Thanks

yngndrw · #6 05-20-2009, 10:45 AM

I'd think it's 3,000 as it's the speed at 50Hz.

(As 400Hz is 24,000RPM.)

Ed Williams · #7 05-20-2009, 12:23 PM

That was it.
Thanks Alot

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with Huanyang HY02D223B	stevespo	Phase Converters and VFD	248	03-15-2012 06:16 PM
Setting 142	behindpropeller	Haas Mills	4	03-10-2009 10:52 AM
Newbie- Setting Z in G54	bloefeld	Haas Mills	19	08-26-2008 09:01 AM
Newbie- Help setting up post process from TCC to Mach3	56speedster	TurboCAD/CAM	0	03-28-2008 10:14 PM
Setting Zero	wjbzone	TurboCNC	7	01-03-2004 04:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)