Digital Machinist?

[revwarguy]

I was thinking about subscribing to Digital Machinist as they advertise it as being about CNC. I am primarily a wood router kinda CNC'er, but would like to do some light aluminum sometime.

I was wondering if anyone else subscribes, and if so, what they think of the magazine. How relevant are the articles to routing? Are there any back issues of interest? I did look at their website, but I really can't tell from that.
TIA,

[nlancaster]

Well I dont know much about the magazine but it does have a free copy option right on the website you can sign up for. I did and I will see what the magazine is like.

[ger21]

Go to your local Barnes and Noble and read it. Check out a few issues, then, if you like it, subscribe.

[nlancaster]

I hate going into books stores too look at/for magazines. they are always rearranging the magazines, so they are never in the same place or even the same section.

[revwarguy]

My local B&N is narrow minded, I guess. They don't seem to carry it. From the lack of response of subscribers, though, I guess not many do. I did request a freebie.