Need Help!- Who all make Ready to Go 4 Axis Controllers

[gunlocators]

I am well aware of the G540 is 4 axis controller where else can a 4 axis controller prewired and enclosed be found besides the gecko products.

If you you know and if you would list the website they can be found

Also i guess NON Ready to go controllers maybe 4 axis kits other than gecko

Thanks Guys

[tumutbound]

You could look at Xylotex. They make a 4 axis controller.

[ger21]

There are a few of inexpensive 4 axis drives out there, but none with a case like the G540, at least that I'm aware of . But you'll find that none of them even come close to the G540's performance.

[CarveOne]

I've been looking at this one (scroll down) http://www.pmdx.com/ for mounting my four G203V drives. The PMDX-132 model.

If any of you here are familiar with it I need any honest good or bad recommendations of it or the company before ordering it. Send a CNC Zone pm if you wish. I haven't seen any mention of it so far but I don't read all of the forums and have not done any searches yet.

I don't need it to be mounted in a cover so that's not a problem for me. I need a breakout board and this looks like a convenient solution that is similar to the G540.

CarveOne