My router project

[Ol'Dusty]

Pre made parts will be very important for me, as I do not have my own shop. I've been milling oiut wood parts with a homeade drill mill and I need far more acuracy for production, so I've decided that this is the way to go. But it will have to be done a piece at a time, paycheck to paycheck and thats probably good. So I can read and understand things before the money goes out. Thanks alot guys I'll be getting my plans within the next two weeks and speaking with Mr Campbell on how to proceed from there. Thanks again.

[twombo]

That is what I have done.

A bit at a time.

I started with the frame and moving table, then the slides, then the screws and z axis carriage, then servos and power supply, finally the massive rolling stand and now I am doing wiring. Been at it for over a year but it is all paid for with no credit card bill and did not dig into savings even once.

I see light at the end of the tunnel and a digitizing probe is the last major item to order.

[Ol'Dusty]

Thats the only way to fly! Thanks twombo!