| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-12-2009, 04:47 PM
| |||
| |||
hi everyone these few questions have probably been asked hundreds of times but here we go, I'm looking at build a low budget mdf cnc machine so i can do a boot build on a car that i am re-building, yes i know it would be easier do just get a hand held router but there's no fun in that i all ready have a Linux distro installed with cnc software but what i really need to know is will http://pminmo.com/3axis/3axis.htm this be ok to control the three motors, what are the best sort of motors to use(please remember i cant spend a lot of money), and finally is there one design i particular that is easy to cut and build out of mdf?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie - To build or not to build Router/Plasma Table | dfranks | CNC Plasma and Waterjet Machines | 10 | 04-07-2011 11:16 PM |
| New Machine Build- +Newbie, CNC string winder build | brownebasses | General Electronics Discussion | 5 | 11-21-2008 12:38 PM |
| Newbie here! Want to build a small CNC | rearwheels | CNCzone Club House | 2 | 11-15-2008 03:02 PM |
| Newbie here. Have a Techno CNC. Can I build my kithchen cabinets? | cncdesigner | WoodWorking | 4 | 06-16-2007 12:08 AM |
| | |
Linear Mode
