drawslides - CNCzone.com-The Largest Machinist Community on the net!

cncman · #1 05-21-2003, 10:28 PM

Has anyone used drawslides for a sliding table cnc machine? Or even used them for both X and Y?

balsaman · #2 05-21-2003, 10:30 PM

I have not but have heard they work ok but can be a pain to keep clean. Once the dust get's in them (and it will) they can get rough.

Eric

WOODKNACK · #3 05-22-2003, 12:32 AM

I have used them. go check out my web page under cnc photos. I couldnt keep the table from slowly moving up and down. They are not precsion slides.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)