Best intentions - Page 3 - CNCzone.com-The Largest Machinist Community on the net!

kfong · #25 03-15-2004, 08:04 AM

I don't think you need to worry about that, I believe it's just a standard parallel port.

Kin Fong

http://www.embeddedtronics.com/

abasir · #26 03-17-2004, 06:46 PM

Originally posted by FRAMEDNLV
I still would like to know where to get the chip. I have been looking for about a month now. Where did you get your?
Chris

You could ask for samples from www.allegromicro.com
Unfortunately, they don't send to my country

lsfoils · #27 03-27-2004, 10:29 PM

Yes, if you loose track of what you are doing, by thinking about the furture (in my case) you may have to backtrack a bit.

http://www.cnczone.com/forums/showth...5&pagenumber=2

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)