cheap V groove bearings, any issues w/these? - CNCzone.com-The Largest Machinist Community on the net!

nicanor76 · #1 06-05-2008, 04:02 AM

Found these V groove bearings. Does anyone see any issues that a newbie like me maybe overlooking? I believe they're replacement bearings for a meat cutter table saw so is made for industrial purpose in mind. He has some U groove as well but 2x as much, so not sure if it's worth the upgrade.

Info:
-table roller bearing
-aproximately 1 9/16 " diameter x 11/16" width with 3/8" bore
-center rolls on a bearing

sawmiller · #2 06-05-2008, 06:20 AM

according to the guys on joes cnc , these have excessive runout and side to side movement. good for meat cutting maybe , but not accurate enuf for our application
dan

nicanor76 · #3 06-05-2008, 12:28 PM

at a little over $2 each, I thought I hit a goldmine. Too bad

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
V-groove guide bearings and rails	Dirtbos	CNC Plasma and Waterjet Machines	25	11-06-2011 08:46 PM
Big cheap bearings?	Chris64	General Metalwork Discussion	8	11-21-2007 06:17 PM
V-Groove Bearings	widgitmaster	DIY-CNC Router Table Machines	24	02-27-2007 03:14 PM
V-groove bearings	2muchstuff	Linear and Rotary Motion	1	11-04-2005 04:01 AM
v groove bearings	CanopyFx	DIY-CNC Router Table Machines	27	10-25-2005 06:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)