| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-08-2004, 11:41 PM
| |||
| |||
Hope you guys can help. For my X Axis I will be using a belt drive system the is to be geared down from 1 to 24 through 2 stages. The first is from the motor to pulley (1 to 4 reduction) and the pulleys will be set on a 25mm shaft that runs through the gantry. Second reduction 1 to 6. The motor is a 880oz Servo. I am trying to work out the recommended belt width to ensure that it is sufficient strenght. Do I use 10mm, 15mm or larger. Pitch will be around 5mm. Other things... 8 * 4 table and cutting plywood etc... Thanks Frans  |
|
#2
08-09-2004, 06:20 PM
| ||||
| ||||
| This one uses 1" wide belts. http://www.axxustech.com/Axxus4x8/axxus_4x8.htm
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
08-09-2004, 06:31 PM
| |||
| |||
| Hello Ger.. thanks for your reply... I have seen that one.. I intend to use the 25mm for that part of the drive, however I am talking about the belts from the motor pulleys to the drive pulley. 25mm would be an overkill on them I think. cheers |
|
#4
08-09-2004, 06:56 PM
| ||||
| ||||
| I think the 10 would be fine. What type of belt do you plan on using (toothform)?
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing belt question | Aegeon | DIY-CNC Router Table Machines | 6 | 05-18-2005 09:50 AM |
| Belt reduction questions Please help!? | Bird_E | General Metal Working Machines | 3 | 11-26-2004 07:55 AM |
| Ballscrew size -vs- project size | Alan T. | CNC Machining Centers | 4 | 10-18-2004 08:53 PM |
| Belt Drive V's Ballscrews | MrBean | DIY-CNC Router Table Machines | 12 | 10-13-2004 02:30 PM |
| How to figure needed stepper motor size? | Hack | General Electronics Discussion | 4 | 07-19-2004 03:43 PM |
| | |
Linear Mode
