Newbie Rockcliff PSU - CNCzone.com-The Largest Machinist Community on the net!

plexer · #1 03-12-2008, 10:17 AM

I'm now thinking about getting around to purchasing some drivers and psu to hook up my steppers, I haven't started building the machine itself yet.

What do you think of the psu's available from:

http://stores.ebay.com/KitsNParts_Po...QQftidZ2QQtZkm

I was thinking maybe the 300w 24v 14.5a would be ok for a small machine?

I'll post details of the drivers I'm going to use in a moment.

Ben

Gir · #2 03-12-2008, 11:14 AM

That should be plenty for a small machine, although upping the voltage is more ideal.

plexer · #3 03-13-2008, 03:49 AM

http://cgi.ebay.com/400W-36V-11A-Swi...742.m153.l1262

400w 36v 11A one then looks good?

Ben

plexer · #4 03-13-2008, 03:52 AM

http://cgi.ebay.com/400W-36V-11A-Swi...742.m153.l1262

400w 36v 11a one looks better then.

Ben

BobF · #5 03-14-2008, 06:14 PM

Originally Posted by plexer

http://cgi.ebay.com/400W-36V-11A-Swi...742.m153.l1262

400w 36v 11a one looks better then.

Ben

Some drivers are happier non-switching power supplys. Match you driver and supply choices.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
my rockcliff cnc build	craigtx	Rockcliff Machine	9	05-31-2008 10:07 AM
2nd rockcliff machine	lgroulx200	DIY-CNC Router Table Machines	0	01-27-2008 02:26 PM
Rockcliff first or Joe?	bartp	Joes CNC Model 2006	4	10-02-2007 08:00 PM
Dons Rockcliff	dwacker	CNC Wood Router Project Log	11	05-05-2007 11:29 PM
Rockcliff	cherman44	Open Source CNC Machine Designs	15	04-30-2007 05:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)