| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-10-2008, 04:01 PM
| |||
| |||
Hi I hope this thread make sense, I wonder how I would go about make a router with 400 to 600mm z-travel. I would like to be able to mill deep pockets in moulds and in wood for radical relief, but I cant have the router brackets hitting the walls of that pocket, and I need good accuracy. Is this a stupid quest or?? Any tip for how to achieve this would be great. A second question is what is a good spindle speed, feed rate, material milling, ratio. I know that its alot of parameters but some guiding in the right direction maybe. I have 5mm threads on the feed-screws and about 600 rpm. I know this is very hard to answer but where should I start? best regards per    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Fanuc OM over travel | malasjo | Fanuc | 5 | 03-10-2008 12:37 PM |
| Alarm 317 Y over Travel Range? | Rocko1 | Haas Mills | 2 | 12-11-2007 04:55 PM |
| step motor for travel | lamicron | Stepper Motors and Drives | 4 | 10-14-2007 10:03 AM |
| Have ballscrew will travel/how far? | lgalla | Linear and Rotary Motion | 0 | 01-10-2007 09:39 PM |
| Travel To Russia | moNkaD8 | Australia, New Zealand Club house | 3 | 08-16-2006 09:16 AM |
| | |
Linear Mode
