I need help with EM-463 stepper - CNCzone.com-The Largest Machinist Community on the net!

DigiSoft · #1 03-08-2008, 08:32 PM

Hi I have fiew questions

1. I have two stepper motors that I want to use them for my new small CNC. They are from Epson C46 and their name is EM-463. I was googling alot but I've couldn't find any info about it. So can someone tell me technical information about this stepper like torque degree etc etc?

2. What is bether to use for drive? Belt or shaft with gears? I am building small CNC mostly for plotting and maby for engraving small and light materials.
If I use gears I think that the CNC will get more precise but it will be much slower. I have 20 tooth gear for the motor and 150 tooth gear for the main power shaft. So if I am not wrong it is 7.5:1? Would this be to slow?

thanks for the help.

cheeswiz · #2 02-07-2009, 12:33 AM

i Am Also looking for information on that Printer's Components. the Micros and the Steppers, any and all info would help me.

I have also Spent several Hours looking for info, mostly on the chips, and i have come up with almost nothing. PLZ Help. ^_^

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Beltdrive-stepper motor-stepper motor driver	Georg	Stepper Motors and Drives	0	10-16-2007 05:56 PM
Wanted DIY stepper driver circuit for 6 wire stepper motors	Colin300	Australia, New Zealand Club house	5	09-20-2007 10:20 PM
STEPPER DRIVER FAQ {Stepper/driver amp per phase match.	huios	Stepper Motors and Drives	0	08-27-2006 09:43 AM
difference between a stepper indexer and a stepper drive	pcroxford	Stepper Motors and Drives	0	11-02-2005 08:35 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)