| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#61
 
07-07-2008, 09:19 AM
| |||
| |||
| We're using 6amp, 960 ounce steppers from San Motion. They are actually the same motors that EZ router uses. The owner was able to buy them directly from EZ router. I'm not sure what the angle pitch of the gear rack is, I'll look into it. We're extremely busy though, don't have much time for the computer this week. Holiday was nice, but now I'm even farther behind. We have been running our machine around 5-25 ipm on alum., 30-50 ipm on plastics. Our fast travel is at 150 ipm's. I know the motors are capable of much higher travel rates, but we don't need to go that fast. Plus, you get a better finish, better tolerances, and our machine will last longer with fewer break downs than the guys that are running at 200 ipm's or faster. Mike  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 80/20 for diy router table? | mjs79 | 80/20, TSLOTS and other Aluminum Framing Systems | 4 | 09-23-2007 12:17 AM |
| New router table | moreil | DIY-CNC Router Table Machines | 5 | 08-29-2006 03:45 AM |
| 4 x 8 router table | lumberjack_jeff | Open Source CNC Machine Designs | 3 | 06-02-2006 07:25 PM |
| router table | planescott | Mechanical Calculations/Engineering Design | 7 | 01-16-2006 12:49 AM |
| Your first CNC Router Table | widgitmaster | DIY-CNC Router Table Machines | 9 | 12-08-2005 12:40 AM |
| | |
Linear Mode
