| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
07-24-2007, 10:33 AM
| |||
| |||
Just picked up a Ridgid R2900 router from depot and so far im loving it, runout is fantastic, ultra quiet, soft start works great, the little led worklights are useless on the cnc but look cool  , only thing i didnt like was the angle of the power cord where it comes out of the back, straight instead of angled, but no biggy.Anybody know where i can get a 1/8" collett for it?  |
|
#2
07-24-2007, 01:24 PM
| |||
| |||
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using a router for the 1st time. Need advice of cut speeds, router bits etc. | Apples | DIY-CNC Router Table Machines | 19 | 09-23-2006 03:33 PM |
| Ridgid Tapping on Haas | Shotout | Haas Mills | 14 | 08-01-2006 09:40 PM |
| going to try it ridgid | dgalaxy | Mechanical Calculations/Engineering Design | 0 | 06-11-2006 03:56 PM |
| ridgid tapping with servos | miljnor | Servo Motors and Drives | 10 | 09-21-2005 01:35 PM |
| Surfcam PP for Isel router / Precix router | IvanTochev | Post Processor Files | 2 | 05-12-2004 12:27 PM |
| | |
Linear Mode
