| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-27-2007, 07:55 PM
| |||
| |||
can I use only my two limits at both end of travel connected to 1 pin for both x+,x- and home , what I mean is, if my limits switches are connected in series on the same pin number , can it also be use as a home switch?    |
|
#3
07-03-2007, 03:46 PM
| |||
| |||
| Mach 3 is the controller I am using, with Bob-Cad design software and Xylotex 3 axis driver. So you just put the same pin number on x-,x+, and home on your pin configuration? Last edited by Claude Boudreau; 07-04-2007 at 06:44 PM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Out of limits | monte55 | Machines running Mach Software | 7 | 11-04-2006 10:28 PM |
| we all need limits! | senor J. | General Electronics Discussion | 28 | 08-24-2006 01:06 AM |
| G-rex home and limits | patrick71100 | Gecko Drives | 1 | 07-20-2006 06:17 AM |
| Home / Limits switches | borrisl | Shopmaster/Shoptask | 12 | 03-30-2006 10:25 PM |
| limits | jc286006 | TurboCNC | 2 | 09-08-2005 06:05 PM |
| | |
Linear Mode
