hobbycnc

[Mr. midnight]

Hello folks out there im needing to know if this is the correct forum to be in if and when i need help.
i just purchased plans and all the parts needed to begin construction on the hobbycnc machine.
im really excited to get started and i know full well the task at hand, i just hope that when trouble comes you good folks will come to the rescue.
as i said i have all the parts coming from differant directions.

i even have the wood working shop cutting most of the wooden parts for me , saving me a little headache.
so in a few days parts will start rolling in, and i can get started.

once the machine is up and running i then can start building my flightsim cockpit.
so folks just wanted to say that im a newbie about to lose his mind
of course i will have to explain to my wife the reason for all the boxes showing up at the doorstep.
But anyway................thanks for listening.Robert

[joecnc2006]

I'm sure any help you need people here are more than willing to help, it is a good community.

Joe

[mlapacz]

Robert,
I finished my HobbyCNC machine in December and have been having a lot of fun cutting airplane parts. I'm using TurboCad, LazyCam, and Mach3 for the software. Let us know if you need any help.
Mike