3\6

[JOE65]

That means private message.

If the motor jumps back and forth like that you need to go into "axis setup" in turbocnc and decrease your values for
1) Max start speed
2) Max speed
3)Acceleration

Start realy low and work up.
Save to the .INI file each time.
Hope this helps

[johntbyrne]

Natchez,

I sent you a Private Message. Go to the bottom of this page and click on the little down arrow by the "Forum Jump:" box. Scroll up to the top and click on Private Message. Didn't want to get too off topic. Just says I live in Vicksburg. My email is jbyrne39056@cs.com. Shoot me an email. Just starting out so have a long way to go. Will have to have you come up when I finally get mine done.

Cheers
John