What do you think about the Stepper world .com FET3 package - Page 5 - CNCzone.com-The Largest Machinist Community on the net!

Sanghera · #49 04-04-2004, 01:56 AM

Thank you very much for the info.
I really appreciate it.

EVO · #50 04-05-2004, 02:08 PM

Don't get the cruiser nema 34 motors. Very slow. The FET3 board is ok for a unipolar board. Buy some nema 23 motors from him or from ebay or whatever if you go with his board. Don't get the sp-ht.

Hi, Balsaman
If I want to get nema23 motor for my FET3, what spec should I look for(V.,A.)?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stepper Package	freezer	DIY-CNC Router Table Machines	23	03-12-2004 11:11 AM
Fun with floppy stepper and driver	Konstantin	General Electronics Discussion	5	03-08-2004 01:18 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)